240×320, General 2inch IPS LCD Display Module

Description Show Reviews Waveshare 17344 – 2inch LCD Display Module, IPS Screen, 240320 Resolution, SPI Interface This is a general LCD display Module, IPS screen, 2inch diagonal, 240320 resolution, with embedded controller, communicating via SPI interface. Features SPI interface, requires minimum GPIO for controlling Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32) Specifications Driver: ST7789 Interface: SPI Display color: RGB, 262K color Resolution: 240320 Backlight: LED Operating voltage: 3.3V Interface SYMBOL DESCRIPTION VCC Power (3.3V input) GND Ground DIN SPI data input CLK SPI clock input CS Chip selection, low active DC Data/Command selection (high for data, low for command) RST Reset, low active BL Backlight Dimensions Development Resources Wiki : www.waveshare.com/wiki/2inch_LCD_Module How to display the Pi desktop on this display: See this manual for the 1.3″ display , Use this in tbtft.conf : options fbtft_device name=flexfb gpios=reset:27,dc:25,cs:8,led:24 speed=40000000 bgr=1 fps=60 custom=1 height=240 width=320 options flexfb setaddrwin=0 width=320 height=240 init=-1,0×11,-2,120,-1,0×36,0x70,-1,0x3A,0x05,-1,0xB2,0x0C,0x0C,0x00,0x33,0x33,-1,0xB7,0x35,-1,0xBB,0x1F,-1,0xC0,0x2C,-1,0xC2,0x01,-1,0xC3,0x12,-1,0xC4,0x20,-1,0xC6,0x0F,-1,0xD0,0xA4,0xA1,-1,0xE0,0xD0,0x08,0x11,0x08,0x0C,0x15,0x39,0x33,0x50,0x36,0x13,0x14,0x29,0x2D,-1,0xE1,0xD0,0x08,0x10,0x08,0x06,0x06,0x39,0x44,0x51,0x0B,0x16,0x14,0x2F,0x31,-1,0×21,-1,0×29,-3 In /boot/config.txt, put a “#” in front of the lines so they look like this: Content 2inch LCD Module x1 PH2.0 20cm 8Pin x1 0 Reviews Hide Reviews Show Reviews