Dual Gigabit Ethernet Base Board Designed for Raspberry Pi CM4

Description Show Reviews Waveshare 19838 – Dual Gigabit Ethernet Base Board Designed For Raspberry Pi Compute Module 4 – CM4-DUAL-ETH-BASE Specifications CM4 socket Suitable for all variants of Compute Module 4 Ethernet Dual Gigabit Ethernet RJ45 USB USB 3.2 Gen1 3 Pin header 40PIN GPIO header 1 HDMI HDMI 2, supports 4K 30fps output DSI display MIPI DSI display port 1, 15pin 1.0mm FPC connector CSI camera MIPI CSI-2 camera port 2, 15pin 1.0mm FPC connector Power input 7V-36V Fan 5V/12V, allows speed adjustment and measurement RTC Real-time clock with battery socket and ability to wake Compute Module 4 SD card slot MicroSD card socket for Compute Module 4 Lite (without eMMC) variants Includes CM4-DUAL-ETH-BASE x1 What’s On Board CM4 socket suitable for all variants of Compute Module 4 40PIN GPIO header for connecting sorts of HATs RJ45 Gigabit Ethernet dual RJ45 Gigabit Ethernet, 10/100/1000M compatible ETHERNET 0: CM4 original ETH ETHERNET 1: USB extended ETH USB 3.2 ports 3x USB 3.2 Gen1, for connecting sorts of USB devices HDMI connector s 2x HDMI, supports 4K 30fps output CAM 2x MIPI CSI camera ports DC power supply 7~36V DC wide voltage range power input Dual LED indicators red: Raspberry Pi power indicator green: Raspberry Pi operating status indicator Micro SD card slot for connecting a Micro SD card with pre-burnt image (Lite variant ONLY) FAN header for connecting cooling fan, allows speed adjustment and measurement DISP0 MIPI DSI display port USB SLAVE port for burning system image into Compute Module 4 eMMC variants RTC battery holder supports CR1220 button cell RTC interruption configuration PI-RUN: CM4 will reboot on RTC interruption GN-EN: CM4 powerdown on RTC interruption D4: D4 pin is triggered on RTC interruption IO-VREF selection set the CM4 IO logic level as 3.3V or 1.8V FAN power supply selection select 5V or 12V power to drive the fan System function configuration BT_DIS: Bluetooth disabled, for CM4 with antenna variant ONLY WiFi_DIS: WiFi disabled, for CM4 with antenna variant ONLY WP_DIS: boot mode switch, ONLY be used when NOT booted from eMMC or SD card RTC/FAN I2C bus selection SDA0/SCL0: I2C-10 is shared with CSI/DSI GPIO3/2: I2C-1 is shared with 40PIN header RTL8153 USB Gigabit Ethernet chip EMC2301 fan controller, allows fan speed adjustment and measurement VL805 USB 3.0 HUB Outline Dimensions Resources WIKI: CM4-DUAL-ETH-BASE * Resources for different product may vary, please check the wiki page to confirm the actually provided resources. 0 Reviews Hide Reviews Show Reviews